Where to Put Carbon Monoxide Detectors (and the 5 Spots to Avoid)
Every winter the furnace, water heater, gas range, and fireplace all run harder, and that is when carbon monoxide problems show up. CO has no smell and no color. A working detector in the right spot is the only warning most people get. Here is where they go, where they do not, and what to do if one goes off.
Quick note: this is general homeowner guidance. Always follow the instructions that come with your detector and your local code, which can be stricter.
Who Needs One
If your home has any fuel-burning appliance (gas or oil furnace, gas water heater, gas stove or dryer, fireplace, wood stove) or an attached garage, you need CO detectors. All-electric homes with no attached garage are lower risk, but a cheap detector near the bedrooms is still smart if you ever run a generator or a space heater that burns fuel.
Where to Put Carbon Monoxide Detectors
- Outside every sleeping area. This is the most important spot. CO is most dangerous when people are asleep and will not notice the headache. Put one in the hallway right outside the bedrooms so the alarm is loud enough to wake everyone.
- On every level of the home, including the basement. If the furnace and water heater are downstairs, the basement detector is your early warning.
- Inside bedrooms where a fuel-burning appliance is nearby, such as a bedroom over the garage or next to the utility room.
- Near the door from an attached garage. A car warming up in the garage is a classic source.
Height matters less than with smoke alarms, because CO mixes with the air. Mount it where the manufacturer says, on the wall or ceiling, and where you can reach it to test it.
5 Spots to Avoid
- Right next to the furnace, water heater, or stove. Appliances can give off a small puff of CO when they first light, which causes nuisance alarms. There is no single distance that applies everywhere. It varies by model and local code (Kidde, for example, gives 5 to 15 feet for some units and 15 feet for others). Check your detector's manual for its exact distance.
- Bathrooms and laundry rooms. Steam and humidity can damage the sensor.
- Next to windows, doors, or vents. Fresh air blowing across it can keep it from reading the room.
- Behind curtains or furniture. The air has to reach it.
- In the garage itself, unless the detector is rated for it. Cold, heat, dust, and exhaust shorten its life and trigger false alarms.
Test, Replace, Repeat
Press the test button once a month. Replace batteries when the alarm signals low battery (your manual lists its chirp patterns), or once a year if it uses replaceable ones. Most importantly, look at the date on the back. CO sensors wear out, and most detectors are made to be replaced after about 5 to 10 years. Many newer units will start an end-of-life chirp when they are done. If you cannot find a date, or it is older than you can remember, replace it. A new plug-in or battery CO alarm usually costs less than a pizza.
If the CO Alarm Goes Off
- Get everyone, pets included, outside into fresh air right away.
- Call 911 or your fire department from outside.
- Do not go back in until responders say it is safe.
- Have the furnace, water heater, and other fuel-burning appliances checked by a qualified technician before using them again.
Headache, dizziness, nausea, or feeling like you have the flu, especially if it gets better when you leave the house, can be signs of CO exposure. Do not wait it out. Get outside and get help.
Winter Habits That Prevent CO Problems
- Never run a generator, grill, or camp stove indoors or in the garage, even with the door open.
- Keep outdoor furnace and water heater vents clear of snow and leaves. A blocked exhaust is a common winter cause. (See Furnace Not Heating? 7 Checks for how to check the vent.)
- Do not use a gas oven to heat the house.
- Get fuel-burning heating equipment checked by a qualified technician before heating season.
Getting a Repair Quote After a CO Scare?
If a technician tells you the furnace has a cracked heat exchanger or needs replacing, that may be true, and it is a safety issue, so do not ignore it. It is also a moment when people get rushed into big quotes. Get the problem shown to you in writing, and get a second opinion if you can. If you want another set of eyes on the quote itself, we offer a written contractor quote review. Safety first, then the paperwork.
TheTradesmanShop